Elements Glaze 4oz
Elements Glaze 4oz
Elements Glaze 4oz
Elements Glaze 4oz
Elements Glaze 4oz
Elements Glaze 4oz

Elements Glaze 4oz

Preço normal
$5.33
Preço promocional
$5.33
Frete calculado no checkout.

Inspired by aspects of nature, Elements™ produce lush, organic, and earthy hues.

Designed to simulate the aesthetic, movement and interest of mid-range and high fire glazes in a cone 06/05 (1830f/1915f) oxidation kiln firing, Elements™ give artists a wide variety of options in one product, as glaze application, firing temperature and shape will influence the outcome of finished work. Elements™ are a two-tone glaze with a main color and a secondary color called a float. When Elements™ are applied to detail pieces, the float color will appear in the crevices. Application and firing will also affect the outcome of main color or float.

Shake for five to six seconds before use. Dispense glaze onto a palette (tile, plate, etc.) and apply with a soft brush or decorating accessory of choice (sponge, stamp, etc.). Dipping your brush directly into the jar may contaminate the jar’s contents, especially if you are using other glazes. Apply three to four coats to your piece. Elements™ glazes were designed to mature at a shelf cone 06 (1830f). When applying them over a large surface area, we recommend a broad, soft fan brush.

Moisten the brush with water first. Then brush fully saturated (loaded) and each coat applied in the same direction. When the wet look has gone from the first coat, you may apply the next coat of glaze. Be sure the glaze has dried thoroughly prior to firing. A medium ramp/firing rate is recommended (250°F per hour) at shelf cone 06 (1830f). Elements™ can be fired at higher temperatures but will change in appearance. We recommend testing prior to use.

Some Elements™ glazes are not to be recommended for dinnerware produced from low fire earthenware clay bodies as these glazes can exhibit surface textures such as cracks and crevices. While the glazed surface may pass lead & cadmium leach tests, and therefore legally considered Food Safe, attempts to adequately clean the textured surface may cause the underlying porous ware to absorb water and fail. Elements™ glazes may be considered dinnerware safe if surface texture is eliminated when firing to mid-range or high fire temperatures. Be sure to double check each glaze for Food Safe and Dinnerware Safe notes.

Amber Ash - FS&DS

Burnished Steel - FS

Copper Adventurine - FS

Sea Green - FS&DS

Grass - FS&DS

While formulated for cone 06/05 (1830f/1915f) use, many of the Elements™ glazes perform beautifully at higher temperatures. Refer to the individual color label for cone 6 (2232f) firing performances. As Elements™ tend to flow at higher temperatures, the orientation at which your glazed ware is fired (flat vs vertical) can greatly impact the look. Due to the movement of the glaze, we recommend limiting the glaze on the bottom third of a vertical piece to avoid running off the ware. We recommend testing to determine color, surface characteristics and movement prior to use. 

Chips shown are fired flat on a white clay body fired to cone 06 (1830f) oxidation. The choice of clay body, the thickness of glaze application, the firing process, and temperature will affect the fired results.